Log Messages
736
ProSafe Managed Switch
QoS

Table 35. Protocol-based VLANs Log Messages

Component Message Cause
Protocol Based
VLANs pbVlanCnfgrInitPhase2Process: Unable to
register NIM callback Appears when nimRegisterIntfChange fails
to register pbVlan for link state changes.
Protocol Based
VLANs pbVlanCnfgrInitPhase2Process: Unable to
register pbVlan callback with vlans Appears when vlanRegisterForChange
fails to register pbVlan for vlan changes.
Protocol Based
VLANs pbVlanCnfgrInitPhase2Process: Unable to
register pbVlan callback with nvStore Appears when nvStoreRegister fails to
register save and restore functions for
configuration save.

Table 36. ACL Log Messages

Component Message Cause
ACL Total number of ACL rules (x) exceeds max
(y) on intf i. The combination of all ACLs applied to an
interface has resulted in requiring more
rules than the platform supports.
ACL ACL name, rule x: This rule is not being
logged The ACL configuration has resulted in a
requirement for more logging rules than the
platform supports. The specified rule is
functioning normally except for the logging
action.
ACL aclLogTask: error logging ACL rule trap for
correlator number The system was unable to send an SNMP
trap for this ACL rule which contains a
logging attribute.
ACL IP ACL number: Forced truncation of one
or more rules during config migration While processing the saved configuration,
the system encountered an ACL with more
rules than is supported by the current
version. This may happen when code is
updated to a version supporting fewer rules
per ACL than the previous version.

Table 37. CoS Log Message

Component Message Cause
COS cosCnfgrInitPhase3Process: Unable to
apply saved config -- using factory defaults The COS component was unable to apply
the saved configuration and has initialized
to the factory default settings.