NETGEAR GSM7228PS-100NAS DNS Client Commands

IP address
Reporting Host
Hardware
Address
Detection
Method
Detection time
Utility Commands
591
ProSafe Managed Switch
DNS Client Commands
These commands are used in the Domain Name System (DNS), an Internet directory
service. DNS is how domain names are translated into IP addresses. When enabled, the
DNS client provides a hostname lookup service to other components.
ip domain lookup
Use this command to enable the DNS client.
Default
Format ip domain lookup
Mode
no ip domain lookup
Use this command to disable the DNS client.
Format no ip domain lookup
Mode
ip domain name
Use this command to define a default domain name that the software uses to complete
unqualified host names (names with a domain name). By default, no default domain name is
configured in the system. <name> may not be longer than 255 characters and should not
include an initial period. This <name> should be used only when the default domain name
list, configured using the ip domain list command, is empty.
Default
Format ip domain name <name>
Mode
Example: The CLI command ip domain name yahoo.com will configure yahoo.com as a default domain name.
For an unqualified hostname xxx, a DNS query is made to find the IP address corresponding to xxx.yahoo.com.
Term Definition
The IP address of the host as recorded on the DHCP server.
The hardware address of the host that reported the conflict.
The manner in which the IP address of the hosts were found on the DHCP Server.
The time when the conflict was found.
enabled
Global Config
Global Config
none
Global Config