NETGEAR GSM7228PS-100NAS show ip pim interface

IP Multicast Commands
351
ProSafe Managed Switch
no ip pim hello-interval
This command resets the transmission frequency of hello messages between PIM enabled
neighbors to its default value.
Format no ip pim hello-interval
Mode
show ip pim interface
This command displays the PIM Interface status parameters. If the interface number is not
specified, this command displays the status parameters of all the PIM enabled interfaces.
Format show ip pim interface <unit/slot/port>
Modes
Mode
Interface
Hello Interval
Join-prune
Interval
DR Priority
BSR Border
Neighbor Count
Designated
-Router
Example 1:
(Switch) #show ip pim interface
Interface 1/0/1
Mode Sparse
Hello Interval (secs) 30
Join Prune Interval (secs) 60
DR Priority 1
BSR Border Disabled
Neighbor Count 1
Designated Router 192.168.10.1
Example 2:
(Switch) #show ip pim interface
Interface 1/0/1
Mode Dense
Hello Interval (secs) 30
Interface Config
Privileged EXEC
Term Definition
Active PIM protocol
Interface number.
Hello interval value. The frequency at which PIM hello messages are transmitted on this
interface. By default, the value is 30 seconds.
Join-prune interval value.
DR Priority configured on this Interface. This is not applicable if the interface mode is
Dense
Is this interface configured as a BSR Border?
Number of PIM Neighbors learnt on this interface. This field is displayed only when the
interface is operational.
IP Address of the elected DR on the Interface. This field is displayed only when the
interface is Operational.