NETGEAR GSM7228PS-100NAS show poe port configuration

Power over Ethernet (PoE) Commands
526
ProSafe Managed Switch
Example:
(switch) #show poe
Firmware Version............................... 1.0.0.2
PSE Main Operational Status.................... ON
Total Power (Main AC).......................... 380
Total Power (RPS).............................. 300
Total Power (PD) .............................. 25
Power Source................................... Main AC
Threshold Power................................ 342
Total Power Consumed........................... 7
Usage Threshold................................ 90
Power Management Mode.......................... Dynamic
Configure port Auto Reset Mode................. Disable
Traps.......................................... Enable
show poe port configuration
Use this command to see how the PoE ports are configured. You can display information based
on each individual port or all the ports collectively.
(Switch) #show poe port configuration all
Admin Power Power Limit High Power Detection
Intf Mode Priority Limit Type Mode Type
(W)
------ ------- -------- ------ -------------- ------------- ---------------------
1/0/1 Enable Low 15.400 User Defined Disable Auto
1/0/2 Enable Low 15.400 User Defined Disable Auto
(Switch) #show poe port configuration 1/0/2
Admin Power Power Limit High Power Detection
Intf Mode Priority Limit Type Mode Type
(W)
------ ------- -------- ------ -------------- ------------- ---------------------
1/0/2 Enable Low 15.400 User Defined Disable Auto
Format show poe port configuration [<port> |All]
Mode Privileged EXEC
User EXEC