Routing Commands
306
ProSafe Managed Switch
show ip ospf

This command displays information relevant to the OSPF router.

Format show ip ospf
Mode

Note: Some of the information below displays only if you enable OSPF

and configure certain features.

Privileged EXEC
Term Definition
Router ID A 32-bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
OSPF Admin
Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled.
This is a configured value.
ASBR Mode Indicates whether the ASBR mode is enabled or disabled. Enable implies that the router
is an autonomous system border router. Router automatically becomes an ASBR when it
is configured to redistribute routes learnt from other protocol. The possible values for the
ASBR status is enabled (if the router is configured to re-distribute routes learned by other
protocols) or disabled (if the router is not configured for the same).
RFC 1583
Compatibility Indicates whether 1583 compatibility is enabled or disabled. This is a configured value.
External LSDB
Limit The maximum number of non-default AS-external-LSA (link state advertisement) entries
that can be stored in the link-state database.
Exit Overflow
Interval The number of seconds that, after entering overflow state, a router will attempt to leave
overflow state.
Spf Delay Time The number of seconds between two subsequent changes of LSAs, during which time
the routing table calculation is delayed.
Spf Hold Time The number of seconds between two consecutive spf calculations.
Flood Pacing
Interval The average time, in milliseconds, between LS Update packet transmissions on an
interface. This is the value configured with the timers pacing flood command.
LSA Refresh
Group Pacing
Time
The size, in seconds, of the LSA refresh group window. This is the value configured with
the timers pacing lsa-group command.
Opaque
Capability Shows whether the router is capable of sending Opaque LSAs. This is a configured
value.
Autocost Ref
BW Shows the value of auto-cost reference bandwidth configured on the router.
ABR Status Shows whether the router is an OSPF Area Border Router.