Routing Commands
329
ProSafe Managed Switch
Any change in the dampening configuration resets the current
penalty, reuse time, and suppressed state to their default values,
meaning 0, 0, and FALSE respectively.
The following shows example CLI display output for the command.
(netgear switch)# show interface dampening
Interface 0/2
Flaps Penalty Supp ReuseTm HalfL ReuseV SuppV MaxSTm MaxP Restart
0 0 FALSE 0 5 1000 2000 20 16000 0
Interface 0/3
Flaps Penalty Supp ReuseTm HalfL ReuseV SuppV MaxSTm MaxP Restart
6 1865 TRUE 18 20 1000 2001 30 2828 1500
Routing Information Protocol (RIP) Commands
This section describes the commands you use to view and configure RIP, which is a
distance-vector routing protocol that you use to route traffic within a small network.

router rip

Use this command to enter Router RIP mode.
Format router rip
Mode

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
Default
Format enable
Mode
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format no enable
Mode
Global Config
enabled
Router RIP Config
Router RIP Config