Utility Commands
556
ProSafe Managed Switch
no logging persistent
Use this command to disable the persistent logging in the switch.
Format no logging persistent
Mode
Email Alerting and Mail Server Commands

logging email

This command enables email alerting and sets the lowest severity level for which log
messages are emailed. If you specify a severity level, log messages at or above this severity
level, but below the urgent severity level, are emailed in a non-urgent manner by collecting
them together until the log time expires. You can specify the severitylevel value as either an
integer from 0 to 7 or symbolically through one of the following keywords: emergency (0),
alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
Default
Format logging email [<severitylevel>]
Mode
no logging email
This command disables email alerting.
Format no logging email
Mode

logging email urgent

This command sets the lowest severity level at which log messages are emailed immediately
in a single email message. Specify the severitylevel value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7). Specify none to indicate
that log messages are collected and sent in a batch email at a specified interval.
Default
Format logging email urgent {<severitylevel> | none }
Mode
Global Config
Disabled; when enabled, log messages at or above severity Warning (4) are emailed
Global Config
Global Config
Alert (1) and emergency (0) messages are sent immediately
Global Config