NETGEAR GSM7228PS-100NAS show port-security , show port-security dynamic

Switching Commands
193
ProSafe Managed Switch
no port-security mac-address sticky
The no form removes the sticky mode. The sticky MAC address can be deleted by using the
command no port-security mac-address <mac-address> <vid>.
Format no port-security mac-address sticky [<mac-address>
<vid>]
Modes • Global Config
• Interface Config
show port-security
This command displays the port-security settings. If you do not use a parameter, the
command displays the settings for the entire system. Use the optional parameters to display
the settings on a specific interface or on all interfaces.
Format show port-security [{<unit/slot/port> | all}]
Mode
Admin Mode
For each interface, or for the interface you specify, the following information appears:
Admin Mode
Dynamic Limit
Static Limit
Violation Trap
Mode
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format show port-security dynamic [lag <lag-intf-num> | <unit/slot/port>]
Mode
MAC Address
Privileged EXEC
Term Definition
Port Locking mode for the entire system. This field displays if you do not supply any
parameters.
Term Definition
Port Locking mode for the Interface.
Maximum dynamically allocated MAC Addresses.
Maximum statically allocated MAC Addresses.
Whether violation traps are enabled.
Privileged EXEC
Term Definition
MAC Address of dynamically locked MAC.