NETGEAR GSM7228PS-100NAS debug spanning-tree bpdu, debug spanning-tree bpdu receive

Utility Commands
614
ProSafe Managed Switch
no debug sflow packet
Use this command to disable sFlow debug packet trace.
Format no debug sflow packet
Mode
debug spanning-tree bpdu
This command enables tracing of spanning tree BPDUs received and transmitted by the
switch.
Default
Format debug spanning-tree bpdu
Mode
no debug spanning-tree bpdu
This command disables tracing of spanning tree BPDUs.
Format no debug spanning-tree bpdu
Mode
debug spanning-tree bpdu receive
This command enables tracing of spanning tree BPDUs received by the switch. Spanning
tree should be enabled on the device and on the interface in order to monitor packets for a
particular interface.
Default
Format debug spanning-tree bpdu receive
Mode
A sample output of the trace message is shown below.
<15> JAN 01 01:02:04 192.168.17.29-1 DOT1S[191096896]: dot1s_debug.c(1249) 101 % Pkt RX
- Intf: 1/0/9(9), Source_Mac: 00:11:88:4e:c2:10 Version: 3, Root Mac: 00:11:88:4e:c2:00,
Root Priority: 0x8000 Path Cost: 0
The following parameters are displayed in the trace message:
Privileged EXEC
disabled
Privileged EXEC
Privileged EXEC
disabled
Privileged EXEC
Parameter Definition
RX A packet received by the device.
Intf The interface that the packet came in on. Format used is unit/port/slot (internal interface
number). Unit is always shown as 1 for interfaces on a non-stacking device.