Routing Commands
248
ProSafe Managed Switch
Mask of the interface. To remove all of the IP addresses (primary and secondary) configured
on the interface, enter the command no ip address.
Format no ip address [{<ipaddr> <subnetmask> [secondary]}]
Mode
ip address dhcp
Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire
network information, such as the IP address, subnet mask, and default gateway from a
network DHCP server. When DHCP is enabled on the interface, the system automatically
deletes all manually configured IPv4 addresses on the interface.
Default
Format ip address dhcp
Mode
no ip address dhcp
Use this command to release a leased address and disable DHCPv4 on an interface.
Format no ip address dhcp
Mode
ip default-gateway
Use this command to manually configure a default gateway for the switch. Only one default
gateway can be configured. If you use this command multiple times, each command replaces
the previous value.
Format ip default-gateway <ipaddr>
Mode
no ip default-gateway
Use this command to remove the default gateway address from the configuration.
Format no ip default-gateway <ipaddr>
Mode
Interface Config
disabled
Interface Config
Interface Config
Global Config
Interface Config