Switching Commands
97
ProSafe Managed Switch
clear radius statistics
This command is used to clear all RADIUS statistics.
Format clear radius statistics
Mode
dot1x guest-vlan
This command configures VLAN as guest vlan on a per port basis. The command specifies
an active VLAN as an IEEE 802.1x guest VLAN. The range is 1 to the maximum VLAN ID
supported by the platform.
Default
Format dot1x guest-vlan <vlan-id>
Mode
no dot1x guest-vlan
This command disables Guest VLAN on the interface.
Default
Format no dot1x guest-vlan
Mode
dot1x initialize
This command begins the initialization sequence on the specified port. This command is only
valid if the control mode for the specified port is “auto” or “mac-based”. If the control mode is
not 'auto' or “mac-based”, an error will be returned.
Format dot1x initialize <unit/slot/port>
Mode
dot1x mac-auth-bypass
This command enables MAC-Based Authentication Bypass (MAB) for 802.1x-unaware
clients. MAB provides 802.1x-unaware clients controlled access to the network using the
devices’ MAC address as an identifier. This requires that the known and allowable MAC
address and corresponding access rights be pre-populated in the authentication server. MAB
works only when the port control mode of the port is MAC-based.
Format dot1x mac-auth-bypass
Mode
Privileged EXEC
disabled
Interface Config
disabled
Interface Config
Privileged EXEC
Interface Config