Quality of Service (QoS) Commands
472
ProSafe Managed Switch
match ethertype
This command adds to the specified class definition a match condition based on the value of
the ethertype. The <ethertype> value is specified as one of the following keywords:
appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios,
novell, pppoe, rarp or as a custom ethertype value in the range of 0x0600-0xFFFF.
Format match ethertype {<keyword> | custom <0x0600-0xFFFF>}
Mode
match any
This command adds to the specified class definition a match condition whereby all packets
are considered to belong to the class.
Default
Format match any
Mode
match class-map
This command adds to the specified class definition the set of match conditions defined for
another class. The <refclassname> is the name of an existing DiffServ class whose match
conditions are being referenced by the specified class definition.
Default none
Format match class-map <refclassname>
Mode
Note the following:
• The parameters <refclassname> and <class-map-name> can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the <refclassname> class while the class is still referenced by any
<class-map-name> fails.
• The combined match criteria of <class-map-name> and <refclassname> must be an
allowed combination based on the class type.
• Any subsequent changes to the <refclassname> class match criteria must maintain this
validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including
both predecessor and successor classes) must not exceed a platform-specific maximum.
Class-Map Config
Ipv6-Class-Map Config
none
Class-Map Config
Ipv6-Class-Map Config
Class-Map Config
Ipv6-Class-Map Config