Management Commands
685
ProSafe Managed Switch
no snmp-server community ipaddr
Use this command to set a client IP address for an SNMP community to 0.0.0.0. The name is
the applicable community name.
Format no snmp-server community ipaddr <name>
Mode
snmp-server community ipmask
Use this command to set a client IP mask for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
address value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 255.255.255.255 will allow access from only one
station, and will use that machine's IP address for the client IP address. A value of 0.0.0.0 will
allow access from any IP address. The name is the applicable community name.
Default
Format snmp-server community ipmask <ipmask> <name>
Mode
no snmp-server community ipmask
Use this command to set a client IP mask for an SNMP community to 0.0.0.0. The name is
the applicable community name. The community name may be up to 16 alphanumeric
characters.
Format no snmp-server community ipmask <name>
Mode
snmp-server community mode
Use this command to activate an SNMP community. If a community is enabled, an SNMP
manager associated with this community manages the switch according to its access right. If
the community is disabled, no SNMP requests using this community are accepted. In this
case the SNMP manager associated with this community cannot manage the switch until the
Status is changed back to Enable.
Default • private and public communities - enabled
• other four - disabled
Format snmp-server community mode <name>
Mode
Global Config
0.0.0.0
Global Config
Global Config
Global Config