NETGEAR GSM7228PS-100NAS storm-control multicast level, storm-control multicast rate

Switching Commands
116
ProSafe Managed Switch
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default
Format storm-control multicast
Mode
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
Format no storm-control multicast
Mode
storm-control multicast level
This command configures the multicast storm recovery threshold for an interface as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default
Format storm-control multicast level <0-100>
Mode
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
Format no storm-control multicast level <0-100>
Mode
storm-control multicast rate
Use this command to configure the multicast storm recovery threshold for an interface in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
disabled
Interface Config
Interface Config
5
Interface Config
Interface Config
Default 0