NETGEAR GSM7228PS-100NAS iscsi enable, iscsi target port

Quality of Service (QoS) Commands
513
ProSafe Managed Switch
iscsi enable
The iscsi enable Global Configuration mode command globally enables iSCSI awareness.
Format iscsi enable
Mode
Default
no iscsi enable
This command is to disable iSCSI awareness use the no form of this command. When User
uses this command, iSCSI resources will be released.
Format no iscsi enable
Mode
Default
iscsi target port
This command configures iSCSI port/s, target addresses and names.
Note: When working with private iSCSI ports (not IANA assigned iSCSI
ports 3260/860), it is recommended to specify the target IP address
as well, so the switch will only snoop frames with which the TCP
destination port is one of the configured TCP ports, AND there
destination IP is the target’s IP address. This way the CPU is not be
falsely loaded by non-iSCSI flows (if by chance other applications
also choose to use these {un-reserved} ports).
When a port is already defined and not bound to an IP, and the User
wants to bind it to an IP, the User should first remove it by using the
no form of the command and then add it again, this time together
with the relevant IP.
Target names are only for display when using show iscsi command.
These names are not use to match (or for doing any sanity check)
Global Config
Disabled
Global Config
Disabled