NETGEAR GSM7228PS-100NAS Console Port Access Commands

Management Commands
641
ProSafe Managed Switch
IPv6 Address/Length is ........................ 3099::210:18FF:FE82:337/64
IPv6 Default Router is ........................ FE80::204:76FF:FE73:423A
Burned In MAC Address.......................... 00:10:18:82:03:37
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Enable
Console Port Access Commands
This section describes the commands you use to configure the console port. You can use a
serial cable to connect a management host directly to the console port of the switch.
configuration
Use this command to access Global Config mode. From Global Config mode, you can
configure a variety of system settings, including user accounts. You can also enter other
command modes, including Line Config mode.
Format configuration
Mode
line
Use this command to access Line Config mode, which allows you to configure various Telnet
settings, ssh settings, and the console port.
Format line {console | telnet | ssh}
Mode
serial baudrate
Use this command to specify the communication rate of the terminal interface. The supported
rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
Format serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 |
115200}
Mode
Privileged EXEC
Global Config
115200
Line Config