Routing Commands
308
ProSafe Managed Switch
The following shows example CLI display output for the command.
(Switch) #show ip ospf
Router ID.....................................2.2.2.2
OSPF Admin Mode...............................Disable
RFC 1583 Compatibility........................Enable
External LSDB Limit...........................No Limit
Exit Overflow Interval........................0
Spf Delay Time................................5
Spf Hold Time.................................10
Opaque Capability.............................Disable
AutoCost Ref BW...............................100 Mbps
Default Passive Setting.......................Disabled
Maximum Paths.................................4
Default Metric................................Not configured
Default Route Advertise.......................Disabled
Always........................................FALSE
Metric........................................Not configured
Metric Type...................................External Type 2
Default Passive
Setting Shows whether the interfaces are passive by default.
Default Route
Advertise Indicates whether the default routes received from other source protocols are advertised
or not.
Always Shows whether default routes are always advertised.
Metric The metric of the routes being redistributed. If the metric is not configured, this field is
blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Number of
Active Areas The number of active OSPF areas. An “active” OSPF area is an area with at least one
interface up.
AutoCost Ref
BW Shows the value of auto-cost reference bandwidth configured on the router.
Maximum Paths The maximum number of paths that OSPF can report for a given destination.
Redistributing This field is a heading and appears only if you configure the system to take routes
learned from a non-OSPF source and advertise them to its peers.
Source The source protocol/routes that are being redistributed. Possible values are static,
connected, or RIP.
Tag The decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Distribute-List The access list used to filter redistributed routes.
Term Definition