NETGEAR GSM7228PS-100NAS spanning-tree configuration revision, spanning-tree edgeport, spanning-tree forceversion

Switching Commands
50
ProSafe Managed Switch
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is
a number in the range of 0 to 65535.
Default
Format spanning-tree configuration revision <0-65535>
Mode
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value.
Format no spanning-tree configuration revision
Mode
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal
spanning tree. This allows this port to transition to Forwarding State without delay.
Default enabled
Format spanning-tree edgeport
Mode
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format no spanning-tree edgeport
Mode
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value.
Default
Format spanning-tree forceversion <802.1d | 802.1s | 802.1w>
Mode
• Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE
802.1d functionality supported).
0
Global Config
Global Config
Interface Config
Interface Config
802.1s
Global Config