Switching Commands
113
ProSafe Managed Switch
maintains the configured “level” (to be active the next time that form of storm-control is
enabled.)
Note: The actual rate of ingress traffic required to activate storm-control is
based on the size of incoming packets and the hard-coded average
packet size of 512 bytes - used to calculate a packet-per-second
(pps) rate - as the forwarding-plane requires pps versus an absolute
rate kbps. For example, if the configured limit is 10%, this is
converted to ~25000 pps, and this pps limit is set in forwarding plane
(hardware). You get the approximate desired output when 512bytes
packets are used.
storm-control broadcast
Use this command to enable broadcast storm recovery mode for a specific interface. If the
mode is enabled, broadcast storm recovery is active and, if the rate of L2 broadcast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of broadcast traffic will be limited to the configured threshold.
Default
Format storm-control broadcast
Mode
no storm-control broadcast
Use this command to disable broadcast storm recovery mode for a specific interface.
Format no storm-control broadcast
Mode
storm-control broadcast level
Use this command to configure the broadcast storm recovery threshold for an interface as a
percentage of link speed and enable broadcast storm recovery. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an
interface increases beyond the configured threshold, the traffic is dropped. Therefore, the
rate of broadcast traffic is limited to the configured threshold.
Default
Format storm-control broadcast level <0-100>
Mode
enabled
Interface Config
Interface Config
5
Interface Config