NETGEAR GSM7228PS-100NAS set mld querier election participate, show mldsnooping querier

Switching Commands
189
ProSafe Managed Switch
set mld querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election
process when it discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier’s source address is better (less)
than the Snooping Querier’s address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
no set mld querier election participate
Use this command to set the snooping querier not to participate in querier election, but go
into a non-querier mode as soon as it discovers the presence of another querier in the same
VLAN.
show mldsnooping querier
Use this command to display MLD Snooping Querier information. Configured information is
displayed whether or not MLD Snooping Querier is enabled.
When the optional arguments vlandid are not used, the command displays the following
information.
Default disabled
Format set mld querier election participate
Mode VLAN Config
Format no set mld querier election participate
Mode VLAN Config
Format show mldsnooping querier [{detail | vlan <vlanid>}]
Mode Privileged EXEC
Field Description
Admin Mode Indicates whether or not MLD Snooping Querier is active on the switch.
Admin Version Indicates the version of MLD that will be used while sending out the queries. This is
defaulted to MLD v1 and it cannot be changed.
Querier Address Shows the IP address which will be used in the IPv6 header while sending out MLD
queries. It can be configured using the appropriate command.
Query Interval Shows the amount of time in seconds that a Snooping Querier waits before sending
out the periodic general query.
Querier Timeout Displays the amount of time to wait in the Non-Querier operational state before moving
to a Querier state.