Routing Commands
266
ProSafe Managed Switch

show ip irdp

This command displays the router discovery information for all interfaces, or a specified
interface.
Format show ip irdp {<unit/slot/port> | all}
Modes • Privileged EXEC
• User EXEC
Interface
Ad Mode
Advertise
Address
Max Int
Min Int
Hold Time
Preference
Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to
view VLAN routing status information.

vlan routing

This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. The
[interface ID] value has a range from 1 to 128. Typically, you will not supply the interface ID
argument, and the system automatically selects the interface ID. However, if you specify an
interface ID that is already in use, the CLI displays an error message and does not create the
VLAN interface.
Format vlan routing <vlanid> [interface ID]
Mode
Term Definition
The <unit/slot/port> that matches the rest of the information in the row.
The advertise mode, which indicates whether router discovery is enabled or disabled on
this interface.
The IP address to which the interface sends the advertisement.
The maximum advertise interval, which is the maximum time, in seconds, allowed
between sending router advertisements from the interface.
The minimum advertise interval, which is the minimum time, in seconds, allowed
between sending router advertisements from the interface.
The amount of time, in seconds, that a system should keep the router advertisement
before discarding it.
The preference of the address as a default router address, relative to other router
addresses on the same subnet.
VLAN Config