Switching Commands
90
ProSafe Managed Switch

show interface ethernet <unit/slot/port> switchport

This command displays the private-VLAN mapping information for the switch interfaces.
Format show interface ethernet <unit/slot/port> switchport
Mode • Privileged EXEC
• User EXEC
Private-vlan host-association
Private-vlan mapping
GARP Commands
This section describes the commands you use to configure Generic Attribute Registration
Protocol (GARP) and view GARP status. The commands in this section affect both GARP
VLAN Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP).
GARP is a protocol that allows client stations to register with the switch for membership in
VLANS (by using GVMP) or multicast groups (by using GVMP).

set garp timer join

This command sets the GVRP join time for one port (Interface Config mode) or all (Global
Config mode) and per GARP. Join time is the interval between the transmission of GARP
Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or
multicast group. This command has an effect only when GVRP is enabled. The time is from
10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
Format set garp timer join <10-100>
Mode • Interface Config
• Global Config
no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the default and
only has an effect when GVRP is enabled.
Format no set garp timer join
Mode • Interface Config
• Global Config
Term Definition
Displays VLAN association for the private-VLAN host ports.
Displays VLAN mapping for the private-VLAN promiscuous ports
20