Nortel Networks 350 manual Describes the Snmp Configuration screen fields

Using the Console Interface

Table 3-3 describes the SNMP Configuration screen fields.

Table 3-3.	SNMP Configuration Screen Fields
Field		Description
Read-Only		The community string used for in-band read-only SNMP operations.
Community String		Default Value:	public
		Range:	Any ASCII string of up to 32 printable characters
Read-Write		The community string used for in-band read-write SNMP operations.
Community String		Default Value:	private
		Range:	Any ASCII string of up to 32 printable characters
Trap #1 IP Address*		Number one of four trap IP addresses. Successive trap IP address fields are
		numbered 2, 3, and 4. Each trap address has an associated community
		string (see Community String).
		Default Value:	0.0.0.0 (no IP address assigned)
		Range:	Four-octet dotted-decimal notation, where each octet is
			represented as a decimal value, separated by a decimal
			point
Community String		The community string associated with one of the four trap IP addresses (see
		Trap #1 IP Address).
		Default Value:	Zero-length string
		Range:	Any ASCII string of up to 32 printable characters
Authentication Trap		Determines whether a trap will be sent when there is an SNMP
		authentication failure.
		Default Value:	Enabled
		Range:	Enabled, Disabled
Link Up/Down Trap		Determines whether Link Up or Link Down traps will be sent from the switch.
		Default Value	Enabled
		Range	Enabled, Disabled

*The Trap IP Address and Community String fields can be set using a MIB table (in a Bay Networks proprietary MIB). The status of the row in the MIB table can be set to Ignore. If the row status is set to Ignore, the fields appear to be set when viewed from the console terminal; however, no traps will be sent to that address until the row status is set to Valid.

304376-B Rev 00 3-13