Nortel Networks 350 manual Default Settings

		Default Settings
Table E-1.	Factory Default Settings for the BayStack 350 Switch (continued)
Field	Default setting	Appears in this CI screen
Autonegotiation	Enabled	High Speed Flow Control Configuration
		(page 3-32)
Flow Control	Disabled

Note: The following two fields only appear when a single Phy MDA with a separate redundant Phy port is installed.

Preferred Phy	Right
Active Phy	Read-only field indicating the
	operational Phy port (Right,
	Left, or None)
Trunk Members	blank field	MultiLink Trunk Configuration
		(page 3-36)
STP	Normal
Trunk Mode	Basic
Trunk Status	Enabled
Trunk Name	Trunk #1 to Trunk #6
Traffic Type	Rx and Tx	MultiLink Trunk Utilization (page 3-39)
Monitoring Mode	Disabled	Port Mirroring Configuration
		(page 3-41)
Monitor Port	Zero-length string
Port X	Zero-length string
Port Y	Zero-length string
Address A	00-00-00-00-00-00
	(no MAC address assigned)
Address B	00-00-00-00-00-00
	(no MAC address assigned)
Packet Type	Both	Rate Limiting Configuration
		(page 3-45)
Limit	None
VLAN	1	IGMP Configuration (page 3-48)
Snooping	Enabled
Proxy	Enabled
Robust Value	2
		(continued)
304376-B Rev 00		E-3