Nortel Networks 350 Appendix E Default Settings, Field Default setting Appears in this CI screen

Appendix E

Default Settings

Table E-1 lists the factory default settings for the BayStack 350 switch.

Table E-1. Factory Default Settings for the BayStack 350 Switch

Field	Default setting	Appears in this CI screen
BootP Request Mode	BootP Disabled	IP Configuration/Setup (page 3-7)
In-Band IP Address	0.0.0.0
	(no IP address assigned)
In-Band Subnet Mask	0.0.0.0
	(no subnet mask assigned)
Default Gateway	0.0.0.0
	(no IP address assigned)
Read-Only Community String	public	SNMP Configuration (page 3-12)
Read-Write Community String	private
Trap IP Address	0.0.0.0
	(no IP address assigned)
Community String	Zero-length string
Authentication Trap	Enabled
Reset Count	1	System Characteristics (page 3-14)
Last Reset Type	Power Cycle
Power Status	Primary Power
sysContact	Zero-length string
sysName	Zero-length string
sysLocation	Zero-length string
		(continued)

304376-B Rev 00 E-1