Chapter 2

Installing the BayStack 350 Switch

This chapter provides the following information about the BayStack 350 switch:

Installation requirements

Installation procedure

Instructions for connecting power

Instructions for verifying the installation

Instructions for the initial switch setup

Refer to Chapter 3, “Using the Console Interface,” to further configure your BayStack 350 switch.

Installation Requirements

Before installing the BayStack 350 switch, verify that the package contains the items shown in Figure 2-1.

Note: Be sure that the supplied AC power cord matches the requirements for your region; see “AC Power Receptacle” on page 1-7.

Install the BayStack 350 switch in a ventilated area that is dust free and away from heat vents, warm air exhaust from other equipment, and direct sunlight. Avoid proximity to large electric motors or other electromagnetic equipment. When choosing a location, observe the environmental guidelines listed in Appendix A, “Technical Specifications.” You will need a Phillips screwdriver for the installation.

304376-B Rev 00

2-1

Page 93
Image 93
Nortel Networks manual Chapter Installing the BayStack 350 Switch, Installation Requirements