Chapter 4 Coax/Twinax (CTHI) Emulation

Graphic Chek Err

Allows overriding of the host setting for the SGEA (Set Graphic Error Action) command. For more information about the SGEA command, refer to the Coax/Twinax Programmer's Reference Manual.

Enable (default). The host setting for the SGEA used by the printer. If the SGEA command is requested to stop on graphic errors, the printer will stop when a graphic error is detected.

Disable. Ignores the SGEA command from the host. The printer does not stop when an error is detected; instead, it substitutes the character selected in the Graphic Chek Code parameter.

Graphic Chek Cod

Specifies the replacement character to print in place of any unprintable character that is received from the host. Choose a hex character from 40 through FE. The character becomes the printer default when:

the printer is powered off and then powered on;

an SGEA command specifies to use the operator panel default;

the Graphic Chek Err parameter is disabled.

LAC Option

Allows the host system to load alternate character images into the printer. This may be used for designing graphics, barcodes, and charts, or for printing in foreign languages.

Enable (default). Prints the LAC character as defined.

Disable. Ignores the LAC definition from the host and prints from the currently selected character set.

184

Page 184
Image 184
Printronix P7000 user manual Graphic Chek Err, Graphic Chek Cod, LAC Option