Dataproducts Parallel Interface Signals
Dataproducts Parallel Interface Signals
Data Lines 1 through 8. Provides eight standard or inverted levels from the host that specify character data, plot data, or a control code. Data Line 8 allows access to the extended ASCII character set. You can enable or disable this line via the Data Bit 8 parameter on the Dataproducts submenu (see page 94).
Data Strobe. Carries a high true pulse from the host when data is ready. The data strobe remains high until the Data Request line goes false. The active edge of the strobe signal can be configured as leading, middle (default), or trailing.
Paper Instruction (PI). Carries a DVFU signal from the host with the same timing and polarity as the data lines.
Ready. Carries a high true signal from the printer when AC power and DC voltages are present, paper is loaded properly, and the printer is not in a check condition.
Online. Carries a high true signal from the printer when the Ready Line is true and the ON LINE key on the control panel has been pressed. When the printer is in online mode, it may accept data from the host.
Demand/Data Request. Carries a high true signal from the printer when the printer is ready to accept character data from the host. This signal changes to false shortly after the leading edge of the data strobe signal.
Cable Verify. Two pins on the interface connector are jumpered together to allow the user to verify proper installation of the interface connector.
Buffer Clear. A high true level from the host to indicate the printer should perform a reboot.
Parity Error. Always carries a low false signal from the printer indicating there is no parity error.
295
