Printronix P7000 user manual Select CPI, Select LPI, Series Sfcc, Margins

Chapter 4 QUICK SETUP

Select CPI

This parameter lets you specify the characters per inch (cpi) values.

Select LPI

This parameter lets you specify the lines per inch (lpi) values.

P-Series SFCC

This parameter allows you to select which ASCII codes will function as the Special Function Control Code (SFCC) command delimiter. P-Series codes can use hex 00 through hex 7F. Options include the following:

•SOH (hex 01) (the default)

•ESC (hex 1B)

•ETX (hex 03)

•CIRCUMFLEX (hex 5E) – also called caret (^)

•TILDE (hex 7E) – (~)

NOTE: SOH, ETX, and ESC are non-printables. The characters (^)

and (~) are printable; however, do not use them as printables in the host data stream if either is chosen as a delimiter because print errors will occur.

Margins

•Left Margin. Set in columns. Column zero is defined as the far left edge of the page, and column numbering increments from left to right.

•Right Margin. Set in columns. Column zero is defined as the far right edge of the page, and column numbering increments from right to left.

•Top Margin. Defined in lines, starting from line zero at the top of the page and incrementing from the top down.

•Bottom Margin. Defined in lines, starting from line zero at the bottom of the page and incrementing from the bottom up.

78