Sharp MX-FX13 Reading XX%, Read END XX%, Memory Auto Auto A4R Standard, Press the Start key

BASIC OPERATIONS

Using the SPF/RSPF

6 Press the [START] key ( ).

MNO	READING	XX%
WXYZ
@.-_	No.001	P-XXX
AD-END	MEMORY	AUTO
	CONT AUTO	A4R
	STANDARD

•Scanning begins.

•If the line is free, the machine will dial the receiving machine and begin transmission as soon as the first page is scanned. (Quick online transmission: page 24)

•If there is a previously stored job or a job is in progress, or if the line is being used, all pages of the original are scanned into memory and stored as a transmission job. (This is called memory transmission: the destination is automatically called and the document transmitted after previously stored jobs are completed.)

If scanning is completed
	READ END	XX%
normally, the following	No.001	P-XXX
screen is appears briefly
	MEMORY	AUTO
and then the display
returns to the base	CONT AUTO	A4R
screen.	STANDARD

Using the document glass

6 Press the [START] key ( ).

MNO	READING	XX%
WXYZ
@.-_	No.001	P-XXX
AD-END	MEMORY	AUTO
	CONT AUTO	A4R
	STANDARD

Scanning begins.

7 If you have another page to scan, change pages and then press the [START] key ( ).

[START]:CONTINUE [#]:READ-END

MEMORY AUTO

CONT AUTO A4R

STANDARD

•Repeat this sequence until all pages have been scanned.

•You can change the resolution and exposure settings as needed for each. (page 14)

•If no action is taken for one minute (the [START] key

( ) is not pressed), scanning automatically ends and the transmission job is stored. (This function can be disabled in the system settings.)

8 After the last page is scanned, press the [READ-END] key ().

	@.-_	READ END	XX%
		No.001	P-XXX
CC. #-C	READ-END	MEMORY	AUTO
		CONT AUTO	A4R
		STANDARD

Open the SPF/RSPF and remove the original. When the original is removed or any key operation is performed, the display returns to the base screen. (The destination is automatically called and the document transmitted after any previously stored jobs are completed.)

•	To cancel transmission
Note	To cancel transmission while "READING" appears or before the key is pressed, press the [C] or [CA] key. To
	cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as explained
	on page 25.

•A job number (3 digits) appears in the display with "READ END" when memory transmission is performed. If you make a note of this number after performing a broadcast transmission, you can use the number to check the results of the transmission in the transaction report or activity report.

•If the power is turned off or a power failure occurs while an original is being scanned in the SPF/RSPF, the machine will stop and an original misfeed will occur. After power is restored, remove the original as explained in "MISFEED IN THE SPF/RSPF" in the Operation Guide for the machine.

18