Sharp MX-FX13 appendix Troubleshooting, Sending result, Explanation, Reception result

	TROUBLESHOOTING
Sending result	Explanation
XX-XX OK	When group dialling, broadcast transmission, or F-code relay request transmission
	was performed,
	xxx- : Indicates total number of transmissions.
	xxx OK : Indicates completed transmissions.
NO S ADD FUNC	When an F-code transmission was attempted,
	(1) The other machine did not have the F-code function.
	(2) An F-code was not programmed in the other machine.
S ADD TX FAIL	When an F-code transmission was attempted,
	(1) The sub-addresses did not match.
	(2) The passcodes did not match.
	(3) An F-code public box was set.
SA POLL ERR	When F-code public box transmission was attempted,
	(1) The F-code public box specified by the sub-address did not exist.
	(2) The sub-address specified a box other than an F-code public box.
PASSCODE# ERR	When F-code public box transmission was attempted,
	(1) The passcodes did not match.
Reception result	Explanation
OK	Reception was completed successfully.
P. FAIL	The power was turned off or a power failure occurred.
MEMORY FULL	The image memory became full during substitute reception to memory.
LENGTH OVER	The transmitted document was over 1500 mm long and therefore could not be received.
NO RX ROLL	When polling was attempted,
	(1) Your fax number (sender's number) was not programmed in your machine.
	(2) Your fax number was not programmed as a polling passcode number in the other
	machine.
RX NO POLL	When polling was attempted,
	(1) The other machine did not have a polling function.
	(2) The other machine did not have a document stored in polling memory.
ERRORxx xxxx	Line conditions prevented the reception from taking place normally.
	First 2 digits of line error code: Error code from 00 to 31.
		7
	Last 4 digits of line error code: Code for use by service technicians.
XX-XX OK	When serial polling ended normally,
	xxx- : Indicates total number of transmissions.
	xxx OK : Indicates completed transmissions.
NO SA POLLING	When F-code polling was attempted,
	(1) The other machine did not have an F-code polling memory function.
	(2) An F-code was not programmed in the other machine.
	(3) The other machine did not have a document stored in polling memory.
SA POL TX ERR	When F-code polling was attempted,
	(1) The sub-addresses did not match.
	(2) The passcodes did not match.
	(3) The other machine's F-code memory boxes were for F-code relay request
	transmission or for F-code confidential transmission.
S ADD RX FAIL	When F-code reception was attempted,
	(1) The sub-addresses did not match or were not programmed.
	(2) The passcodes did not match or were not programmed.
	(3) An F-code polling memory box was programmed.
JUNK FAX ERR	Fax reception was denied by the reception denial function.

91