Sharp MX-FX13 Using F-Code Polling Memory, Scanning a document into an F-code polling memory box

TRANSMISSION USING F-CODES

USING F-CODE POLLING MEMORY

In order for another machine to retrieve a document from your machine, you must first scan the document into the F-code polling memory box.

You can check the document in the memory polling box by printing it out. (See "Checking and clearing document data in a box" on page 56.)

Note When using F-code polling memory, do not set the reception mode to manual reception.

Scanning a document into an F-code polling memory box

The procedure for scanning a document into an F-code polling memory box (page 81) is in general the same as "Scanning a document into polling memory (the Public Box)" on page 38.

1 Perform steps 1 through 4 of "Scanning a document into polling memory (the Public Box)" (page 38).

2 Select "S.A.M-POLL ORIG" with the [ ] or [ ] key.

ED COPY LEX SCAN LEX SCAN

PQ

ACC

SELECT READING

MEMORY POLLING

S.A.M-POLL ORIG

4

3 Press the [OK] key.

GHI

BACK OK

PQRS

4 Select the name of the polling memory box with the [] or [] key.

SEL S.A. POLL BX

Document Plan

Document Tech

- - - - - -

[#]:LISTDETAIL

If not all letters of the programmed name appear, press the key to display all letters. Press the key again to return to the previous display.

About the steps that follow

See steps 6 through 10 in "Scanning a document into polling memory (the Public Box)" (pages 38 to 39). Where "public box" (page 38) appears in the procedure, substitute "F-code polling memory box".

55