Sharp MX-FX13 appendix Startenter, Others, Select SUB Address with the or key, Code settings

PROGRAMMING

11 Press the [OK] key.

OK

12 Enter search characters (see "ENTERING CHARACTERS" on page 86).

26	27	28	29	30	KEY WORDS
A	B	C	D	E
31	32	33	34	35	ABCDE
36	37	38	39	40
F	G	H	I	J
K	L	M	N	O
41	42	43	44	45	ABC
46	47	48	49	50
P	Q R		S	T	[START]:ENTER
U	V	W	XYZ	SP

Up to 10 search characters can be entered.

Only "Uppercase" characters should be used in "KEY WORD" to arrange the addresses in alphabetical order.

The search characters function as a keyword if you need to search for the destination when sending a fax. (Page 20)

13 To finish the storing procedure, press the [START] key ( ). If you wish to program an option such as an F-code, chain dialling, transmission speed, or international transmission mode, press the [OK] key.

•If you pressed the [START] key ( ), you will return to step 7. If you wish to store another Rapid key or Speed Dial number, repeat steps 7 to 13. If you have finished storing auto-dial numbers, press the [BACK] key.

•If you pressed the [OK] key, go to the appropriate page for the option that you wish to program.

To program F-code settings, see "F-code settings" which follows.

To select "CHAIN DIAL", go to "Chain Dialling" on page 69.

To set the "TRANSMISSION SPEED", go to "Transmission speed setting" on page 70.

To set the "INTERNATIONAL TRANSMISSION MODE", go to "International transmission mode setting" on page 70.

About the setting options

Note	When storing and editing Rapid keys and Speed Dial numbers, you can also select the setting options below.
	Chain dialling cannot be combined with any of the other setting options.
	When you select a setting option, a checkmark appears in the setting option screen.
	•	F-code	A sub-address and passcode can be stored for F-code communication.
			(See below.)
	•	Chain Dialling	You can enable or disable Chain Dialling for a Rapid key or Speed Dial
			number. (Page 69)
	•	Transmission speed	You can set the transmission speed to 33,600 bps (maximum speed),
			14,400 bps (high speed), 9600 bps (middle speed), or 4800 bps (low
			speed). The initial setting is 33,600 bps (maximum speed). (Page 70)
	•	International transmission mode . . .	The international transmission mode can be set to "OFF" or one of modes
			1 to 3. The initial setting is "OFF". (Page 70)

[F-code settings]

To program F-code settings, complete steps 1 through 13 on pages 66 to 68 and then follow the steps below.

1 Select "SUB ADDRESS" with the [ ] or [ ] key.

PQ	OTHERS
	SUB ADDRESS
ED COPY	CHAIN DIAL
LEX SCAN	[ ]:CANCEL
LEX SCAN
ACC	[START]:ENTER

2 Press the [OK] key.

GHI

BACK OK

PQRS

68