Sharp MX-FX13 appendix Faxing a TWO-SIDED Original MX-M182D/MX-M202D/MX-M232D, Sided, Duplex Scan

BASIC OPERATIONS

FAXING A TWO-SIDED ORIGINAL (MX-M182D/MX-M202D/MX-M232D)

Follow the steps below to automatically transmit both sides of a two-sided original. (This is only possible on models that have an RSPF installed.)

Do not use an original that is not a standard size (A3, B4, A4, A4R, A5, 8-1/2" x 11", 8-1/2" x 11"R (11" x 17", Note 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, A4, A4R if the machine uses inch-based paper sizes)).

Otherwise a scanning error or cut-off image may result.

1 Make sure that the machine is in fax mode.

			When the machine is in fax
SCAN			mode, the [FAX] key indicator is
FAX	LINE C		lit. If the indicator is not on, press
	DATA	S	the [FAX] key. If auditing mode
G
		F	has been enabled for the fax

function in the system settings, a message will appear prompting

you to enter your account number when you switch to fax mode. Enter your account number (five digits) with the numeric keys. (See "ACCOUNT CONTROL" on page 103.)

2 Place the original(s) in the document feeder tray. (See "USING THE SPF/RSPF" on page 12.)

3 Check the original size.

RATIO AUTO IMAGE		OUTPUT 2-SIDED COPY	ORIGINAL SIZE
RESS	FORMAT	ORIGINAL SIZE DUPLEX SCAN
RESS	BROADCAST ORIGINAL SIZE DUPLEX SCAN		AB

AUTO

A3

B4

When the [ORIGINAL SIZE] key is pressed, the size selection screen appears. If the original size was not correctly detected, see "MANUALLY SETTING THE SCANNING SIZE" (page 13) and set the correct original size.

4 Press the [DUPLEX SCAN] key.

MAGE	OUTPUT	2-SIDED COPY	DUPLEX SCAN
MAT	ORIGINAL SIZE DUPLEX SCAN

CAST ORIGINAL SIZE DUPLEX SCAN

1-SIDED

2-SIDED

The duplex mode selection screen appears.

5 Select "2-SIDED" with the [] or [ ] key.

PQ	DUPLEX SCAN
	1-SIDED
DED COPY	2-SIDED
LEX SCAN	2
LEX SCAN
ACC
6 Press the [OK] key.
	The duplex original type
GHI	selection screen appears.
BACK OK

PQRS

7 Select book or tablet for the duplex original type with the [ ] or [] key.

DUPLEX SCAN

BOOKLET

8 Press the [OK] key.

You will return to the base screen and the duplex scanning mode icon will appear.

9 Continue from step 4 of "BASIC PROCEDURE FOR SENDING FAXES" (page 17).

•	Booklets and tablets	Booklet	Tablet
Note	Two-sided originals that are bound at the side are booklets, and two-sided originals
	that are bound at the top are tablets.

•Duplex scanning is cancelled when the transmission is completed, or when the [CA] key is pressed.

•Duplex scanning of two-sided originals is only possible when an RSPF is used. Automatic scanning of both sides of an original is not possible when the document glass is used.

•Automatic scanning of both sides of an original longer than A3 (11" x 17") is not possible.

•The image of the back side of the original is rotated 180 degrees if needed at the time of transmission, and thus there is no need to change the orientation at the receiving machine.

•To cancel duplex scanning, select "1-SIDED" in step 5 and then press the [OK] key.

•When duplex scanning is enabled, dual page scan (page 42) cannot be enabled.

21