Sharp MX-FX13 Searching For A Programmed Destination Using The Address Key, Parker, Johnson

BASIC OPERATIONS

SEARCHING FOR A PROGRAMMED DESTINATION (USING THE [ADDRESS] KEY)

At the time of dialling, you can enter letters to search for a destination stored in a Rapid key, Speed Dial number, or Group key.

1 Perform steps 1 to 4 of "BASIC PROCEDURE FOR SENDING FAXES" (page 17).

2 Press the [ADDRESS] key.

OSURE	PAPER SELECT COPY RATIO		AUTO IMAGE	OUTP	KEY WORDS
UR MODE	RESOLUTION	ADDRESS	FORMAT	ORIGINAL
GRAM	RESOLUTION	ADDRESS	BROADCAST	ORIGINAL

ABC

The search letter entry screen appears.

5 Select the desired destination with the [] or [] key.

PQ	ADDRESS
	Johnson
DED COPY	Parker
LEX SCAN	Stevens
LEX SCAN
ACC	[#]:LIST DETAIL

•The search results appear in the following order: upper case letters, lower case letters, special characters, and numbers.

•If not all letters of the destination name appear, press the key to display the full name. Press the key once again to return to the original screen.

3 Enter the search letters with the letter entry keys (page palette) (you can also skip entry of search letters and go directly to the next step to display the first destination in the address list).

26	27	28	29	30	KEY WORDS
A	B	C	D	E
31	32	33	34	35	A
F	G	H	I	J
36	37	38	39	40
K	L	M	N	O
41	42	43	44	45	ABC
46	47	48	49	50
P	Q R		S	T	[OK]:SEARCH
U	V	W	XYZ	SP

Up to 10 of the following types of characters can be entered.

Upper case letters, lower case letters, numbers, special characters (See "ENTERING CHARACTERS" on page 86.)

Enter numbers with the numeric keys.

4 Press the [OK] key.

GHI	ADDRESS
	Johnson
BACK OK
PQRS	Parker
	Stevens
The address list appears.	[#]:LIST DETAIL

6 Press the [OK] key.

OK	The selected destination is
	entered.

7 Continue from step 6 of "BASIC PROCEDURE FOR SENDING FAXES" (page 18).

•	To cancel transmission
Note	To cancel transmission while "READING"
	appears or before the key is pressed,

press the [C] or [CA] key. To cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as explained on page 25.

•A job number (3 digits) appears in the display with "READ END" when transmission is performed. If you make a note of this number after performing a broadcast transmission, you can use the number to check the results of the transmission in the transaction report or activity report.

20