Sharp MX-FX13 appendix Chain Dial, Sub Address, Press the OK key, Return to on page

PROGRAMMING

3 Enter a sub-address (maximum 20 digits) with the numeric keys.

	ABC	DEF	SUB ADDRESS
GHI	JKL	MNO
OK
PQRS	TUV	WXYZ	:123
		@.-_
ACC. #-C		READ-END

[Chain Dialling]

To set an auto-dial number as a Chain Dial number, complete steps 1 through 13 on pages 66 to 68 and then follow the steps below.

When a number is set as a Chain Dial Note number, the destination fax number entered

in step 8 on page 67 can be up to 48 digits long.

Characters that can be entered are numbers, " ", "#", and spaces. If you make a mistake, press [C] key and then re-enter the correct number.

When this step is referred to in the following procedures, " ", "#", and spaces cannot be entered.

•PROGRAMMING AN F-CODE CONFIDENTIAL BOX (step 11 on page 79)

•Editing an F-code confidential box (step 17 on page 82)

•PROGRAMMING AN F-CODE RELAY GROUP (step 11 on page 80)

•Editing an F-code relay group (step 15 on page 83)

•PROGRAMMING F-CODE PUBLIC (POLLING MEMORY) BOXES (step 11 on page 81)

•Editing an F-code public box (step 15 on page 84)

4 Press the [OK] key.

5 Enter a passcode (maximum 20 digits) with the numeric keys.

WXYZ

PASS CODE

:

•Characters that can be entered are numbers, " ", "#", and spaces. If you make a mistake, press [C] key and then re-enter the correct number.

•If desired, you can omit the passcode.

When this step is referred to in the following procedures, spaces cannot be entered.

•PROGRAMMING AN F-CODE CONFIDENTIAL BOX (step 12 on page 79)

•Editing an F-code confidential box (step 18 on page 82)

•PROGRAMMING AN F-CODE RELAY GROUP (step 12 on page 80)

•Editing an F-code relay group (step 15 on page 83)

•PROGRAMMING F-CODE PUBLIC (POLLING MEMORY) BOXES (step 12 on page 81)

•Editing an F-code public box (step 15 on page 84)

6 Press the [OK] key.

When you press the [OK] key, you return to the option setting screen and a checkmark appears to the left of "F-CODE".

To cancel the F-code setting, press the key to remove the checkmark.

7 Return to step 13 on page 68.

1 Select "CHAIN DIAL" with the [ ] or [ ] key.

OTHERS

SUB ADDRESS

CHAIN DIAL

TX SPEED

[START]:ENTER

•If checkmark appears to the left of "CHAIN DIAL", it is already selected.

•To exit, press the [START] key ( ).

2 Press the [OK] key.

OK

3 Select "ON" or "OFF" with the [] or [] key.

CHAIN		DIAL
			6
	ON
	OFF

If chain dialling was already selected in step 7 and you wish to cancel the selection, select "OFF".

4 Press the [OK] key.

OK

After you select "ON" and press the [OK] key, you will return to the option setting screen and a checkmark will appear to the left of "CHAIN DIAL".

If you pressed the key, the checkmark will be removed and chain dialling cancelled.

5 Return to step 13 on page 68.

69