Sharp MX-FX13 appendix Storing transmission jobs memory transmission, Enter Dial #

BASIC OPERATIONS

8

MNO

WXYZ

@.-_

AD-END

Press the [START] key.	Note	•	To change from "Direct Transmission"
			back to "Memory Transmission", select
When using the document			"MEMORY TX" in step 5.
		•	To cancel a direct transmission, press the
glass, multiple original pages			[C] key.
cannot be transmitted in a
single transmission.

Faxing by manual transmission (using the [SPEAKER] key)

1 Perform steps 1 to 4 of "BASIC PROCEDURE FOR SENDING FAXES" (page 17).

2 Press the [SPEAKER] key

ENTER DIAL #

3 Perform steps 7 and 8 of "Faxing by direct transmission" (page 22 to 23).

•	To cancel dialling using the [SPEAKER]	2
Note	key when you need to redial the number
	or because transmission was interrupted,

press the [SPEAKER] key once again.

• As the original is not stored in memory

when direct transmission and manual

transmission are used, the following

SPEAKER

:

functions cannot be used.

	COPY	MANUAL	AUTO
SHIFT
REDIAL/PAUSE	PRINT	CONT AUTO
		STANDARD

When this key is pressed, a message regarding volume adjustment will appear briefly followed by the dial entry screen. You can adjust the speaker volume (high, middle, or low) by pressing the [ ] or [ ] key. Note that this will not change the volume setting in the system settings. Ringing will be heard from the speaker on the left side of the machine (toward the back) when the [SPEAKER] key is used for dialling.

Broadcast transmission (page 31), timer

transmission (page 33), F-code relay

broadcast transmission (page 63), redial

(page 107), image rotation (page 105),

duplex scanning, dual pages, and others.

• When a fax is sent by direct transmission

or manual transmission, the fax is sent

after the connection with the receiving

machine is established.

Storing transmission jobs (memory transmission)

When the line is in use, the transmission job is temporarily stored in memory. When the current job and any previously stored jobs are completed, transmission begins automatically. (This is called memory transmission.) This means that transmission jobs can be stored in memory by performing a transmission operation while the machine is occupied with another transmission/reception operation. Up to 50 jobs can be stored in memory at once. After transmission, the scanned document data is cleared from memory. You can check transmission jobs stored in memory in the fax job status screen. (Page 26) Note that depending on the number of pages stored in memory and the transmission settings, it may not be possible to store 50 jobs in memory.

•The procedure for storing a transmission job is the same as the procedure in "BASIC PROCEDURE FOR SENDING FAXES" on page 17.

•If you have not yet pressed the [START] key ( ), you can cancel a transmission job by pressing the [C] key.

•If you have already pressed the [START] key ( ), see "Cancelling a stored transmission job" (page 26). If the original is still being scanned after the [START] key ( ) is pressed, you can press the [C] key to cancel the transmission.

•If you store a transmission job in direct transmission mode, you will not be able to store any further transmission jobs.

After transmission, the scanned document data is cleared from memory. You can check transmission jobs stored in memory in the fax job status screen. (Page 26)

If the memory becomes full during transmission of a stored transmission job

If the memory becomes full while scanning the first page of a document, the transmission job is automatically cancelled. If the memory becomes full while scanning the second page or a following page, scanning stops. In this case, you can either press the [C] key to cancel the transmission, or press the [OK] key to transmit only those pages which were completely scanned.

23