Sharp MX-FX13 appendix Press the Start key to end the procedure, Programming AN F-CODE Relay Group

PROGRAMMING

[PROGRAMMING AN F-CODE RELAY GROUP]

This procedure is used to program an F-code relay group box for relay broadcast of a received fax upon receipt of an F-code relay request. Up to 10 boxes can be programmed. An F-code (sub-address and passcode) for reception of an F-code relay request and the destinations to which the fax is to be relayed are programmed in each box. To check the contents of a programmed box, print the following list: "PRINT - REPORT - SUB ADD SET LIST" (page 85).

To program an F-code relay group box, follow steps 1 through 6 on page 78 and then follow the steps below.

7 Select an unused box ("- - - - - -") with the [ ] or [ ] key.

PQ	S.A.		RELAY			GRP
	SBC		CO.
ED COPY	—	—	—	—	—	—
LEX SCAN	—	—	—	—	—	—
LEX SCAN
ACC	[OK]:STORE				START

8 Press the [OK] key.

GHI

BACK OK

PQRS

12 Enter a passcode (maximum 20 digits) with the numeric keys.

See steps 5 and 6 on page 69.

13 Enter the relay destinations. Enter full fax numbers with the numeric keys and/or press auto-dial keys (Rapid keys, Speed Dial numbers, and group keys) to select the destinations (page 19).

ENTER RX STATION

WXYZ

26	27	28	:
A	B		C
31	32	33
F	G	38	H
36	37

•To clear a mistake when entering a number with the numeric keys, press the [C] key to clear one digit at a time.

•A destination selected with a Rapid key, Speed Dial number, or group key is indicated by an icon and a number. To clear an entry, press the [C] key.

14 Press the [OK] key and then dial the fax number of the next destination or press an auto-dial key.

9 Enter a name for the F-code relay group box (see "ENTERING CHARACTERS" on page 86).

26	27	28	29	30		ENTER GRP NAME
	A	B	C	D	E
31	32	33	34	35
	F	G	H	I	J
36	37	38	39	40
	K	L	M	N	O
41	42	43	44	45		ABC
46	47	48	49	50	T
	P	Q	R	S
	U	V	W	XYZ	SP

GHI

BACK OK

PQRS

•After entering a full number with the numeric keys, press the [OK] key to complete the entry. If you pressed an auto-dial key in step 13, it is not necessary to press the [OK] key. You can immediately press another auto-dial key for the next destination.

•Repeat steps 13 and 14 until all destinations have been entered.

Up to 36 characters can be entered for the name. A box name must be entered.

10 Press the [OK] key.

OK

11 Enter a sub-address (maximum 20 digits) with the numeric keys.

See steps 3 and 4 on page 69.

15 Press the [START] key ( ) to end the procedure.

MNO

WXYZ

@.-_

AD-END

80