Sharp MX-FX13 appendix Using Settings Stored AS a Program, Using a Program, Corp #LIST Detail

USING SETTINGS STORED AS A PROGRAM

This function allows you to store the steps of an operation, including the destination and scanning settings, into a program. This function is convenient when you frequently send documents, such as a daily report, to the same destination. Up to nine programs can be stored.

When storing a program, a name (maximum 36 letters) can be assigned to the program.

For information on storing, editing, and deleting programs, see "STORING, EDITING AND DELETING PROGRAMS" on page 76. The following settings can be stored in a program:

(1)Transmission method

Normal transmission (page 17), broadcast transmission (page 31), polling (page 35), serial polling (page 37), F-code transmission (page 59), F-code polling (page 57)

(2)Cover sheet / message (page 43)

(3)Resolution and exposure (page 14)

(4)Dual page scan (page 42)

(5)Transmission settings (page 22)

When storing a broadcast transmission or serial polling operation in a program, up to 200 destination fax numbers can be stored.

• A program differs from a timer transmission (page 33) in that it is not cleared from memory after transmission

Note takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however, that programs do not allow you to establish a timer setting for transmission.

•A setting that can be stored in a program cannot be changed at the time that a program is used for a transmission even if the setting is not stored in the program.

•The only settings that can be selected when using a program are the original size, duplex scanning, and a timer setting.

USING A PROGRAM

1 In fax mode, place the original. (Page

12)

SCAN			Skip this step if polling, serial
			polling, or F-code polling is being
FAX	LINE	C	performed. If you are going to use
	DATA
		S	Dual Page Scan (page 42), place
G		F
			the document on the Document

glass.

(To select fax mode, see step 1 on page 17.)

2 Press the [PROGRAM] key.

4 Press the [OK] key.

5 If needed, select the original size and other settings, and then press the [START] key ( ).

MNO

WXYZ

@.-_

AD-END

LINE	COPY	EXPOSURE	PAPER SELECT COPY RA
DATA
	SCAN	COLOUR MODE	RESOLUTION	ADDRE
	FAX	PROGRAM RESOLUTION		ADDRE

The program selection screen appears.

PROGRAM

A CORP.

B CORP.

- - - - - -

[#]:LISTDETAIL

Transmission takes place according to the program.

Select settings that cannot be stored in a Note program before you press the [START] key

( ) in step 5. These settings include the original size (see "MANUALLY SETTING THE SCANNING SIZE" on page 13), duplex scanning (see "FAXING A TWO-SIDED ORIGINAL

3 Select the program that you wish to use with the [] or [] key.

BACK	OK	PROGRAM
	PQ	A	CORP.
EX SCAN		B	CORP.	- -
		-	- - -
ED COPY		[#]:LIST		DETAIL
EX SCAN

If not all letters of the program name appear, press the key to display all letters. Press the key once

again to return to the original screen.

(MX-M182D/MX-M202D/MX-M232D)"on page 21), and a timer setting (see

"AUTOMATIC TRANSMISSION AT A SPECIFIED TIME (TIMER TRANSMISSION)" on page 33).

44