Sharp MX-FX13 Storing, Editing And Deleting Programs, Enter, Entry, Select ENTRY with the or key

PROGRAMMING

STORING, EDITING AND DELETING PROGRAMS

You can store a transmission method*, cover sheet/message, transmission settings, dual pages, and/or resolution/exposure settings in a program. This will allow you to use the settings for a transmission by means of a simple operation (see "USING A PROGRAM" on page 44).

*Transmission methods: normal transmission, broadcast transmission, polling, serial polling, F-code transmission, F-code polling

Note An original size setting, screen setting, and timer transmission setting cannot be stored in a program.

To store a program, follow steps 1 through 6 on pages 66 to 67 and then follow the steps below.

1 Select "ENTRY" with the [ ] or [ ] key.

PQ	SPECIAL FUNCTION
	ORIGINAL STORE
ED COPY	PRINT
LEX SCAN	ENTRY
LEX SCAN
ACC

•To edit a program, select "CHANGE" and press the [OK] key. Next, follow the steps in "EDITING PROGRAMS" on page 77.

•To delete a program, select "DELETE" and press the [OK] key. Next, follow the steps in "DELETING PROGRAMS" on page 77.

[STORING A PROGRAM]

6 Select the program that you wish to store with the [] or [] key.

2 Press the [OK] key.

GHI

BACK OK

PQRS

3 Select "PROGRAM" with the [ ] or [] key.

ENTRY

DIAL

PROGRAM

SUB ADD SETTING

4 Press the [OK] key.

5 Select "ENTER", "CHANGE", or "DELETE" with the [] or [] key.

PROGRAM

ENTER

CHANGE

DELETE

•To store a program, select "ENTER" and press the [OK] key. Continue from step 6 of "STORING A PROGRAM".

PROGRAM

XXXXXX

— — — — — —

— — — — — —

If you select a program that has already been stored, a message appears. Select a program that has not been stored, or clear the program (page 77) and then select it.

7 Press the [OK] key.

8 Enter a program name (see "ENTERING CHARACTERS" on page 86).

26	27	28	29	30		PROGRAM NAME
	A	B	C	D	E
31	32	33	34	35		ABCDE
36	37	38	39	40	J
	F	G	H	I
	K	L	M	N	O
41	42	43	44	45		ABC
46	47	48	49	50	T
	P	Q	R	S
	U	V	W	XYZ	SP

Up to 36 characters can be stored for the name of the program. A program name must be entered.

9 Press the [OK] key.

76