Zhone Technologies IMACS-200 manual Default for Signal Conversion is off

Table 6-2summarizes the configuration settings for the FXS ports, along with the available and factory-default option settings. The parameters and settings are also described in the following paragraphs.

Parameter		User Options	Notes	Default
STATE	stdby	actv		stdby
WAN/SRV	none	wan-1 wan-2 wan-3 wan-4 owan-1		none
	owan-2 owan-3 owan-4
TS	01-24 or 01-31			01
MODE	fxs plar			fxs
Rx TLP	-9.0 dB to +3.0 dB			-2.0
Tx TLP	-9.0 dB to +6.5 dB			2.0
CODING	u-law a-inv		1	u-law
LB	off	dgtl anlg		off
PATTERN	none	D-mW		none
SIG CONV	n/a on off		2	off

Table 6-2. Main Screen Option Settings and Defaults

Notes:

1.All four ports must be set to either u-law or a-inv.

2.When a WAN or SRV port has not been selected, n/a. Once a port has been chosen then the default is

the default for Signal Conversion is off.

STATE

The State setting determines whether the port is active or inactive. An inactive port does not occupy a time slot on a WAN link. Set the State setting to stdby (standby) for ports that are not to be used or that have not yet been configured. Set it to actv (active) for ports that are ready for use.

WAN

The WAN setting identifies the WAN or OWAN link assigned to this port. When choosing the type of wan, you must also select the desired port of the WAN or OWAN port for transmission over the T1 or E1 link.

It is not necessary to assign all FXS ports to the same WAN or OWAN link, nor to contiguous time slots on a WAN or OWAN link.

FXS Ports 6-3