Zhone Technologies IMACS-200 manual Main Screen Actions, Action Function

	Table 7-1. Main Screen Actions
Action	Function
Save	Saves changes to settings.
Undo	Returns all settings to the last saved state.
Refresh	Updates certain time-related information fields that are not automatically
	updated (i.e., test status).
Copy	Copies the contents of the current column to the next column. Useful if you
	change a lot of entries in one column and wants to repeat those changes in
	subsequent columns.
Test	Access is given to the test screen
taBs	Index into the signaling conversion screen.
Main	Returns to the System Main Screen. If you make changes to settings and do
	not save them, you will be prompted to save or lose changes.

Table 7-2, “Main Screen Option Settings and Defaults,” on page 7-7summarizes the configuration settings for the E&M port, along with the available and factory-default option settings. The parameters and settings are also described in the following paragraphs.

Table 7-2. Main Screen Option Settings and Defaults

Parameter		User Options	Notes	Default
STATE	stdby	actv		stdby
WAN/SRV	none	wan-1 wan-2 wan-3 wan-4 owan-1 owan-2		none
	owan-3 owan-4
TS	01-24 or 01-31			01
MODE	to e&m I e&m II e&m IV e&m V			to
Rx TLP	-16.3 dB to +7.5 dB			0
Tx TLP	-16.3 dB to +7.5 dB		1	0
CODING	u-law a-inv			u-law
LB	off	dgtl anlg		off
PATTRN	none	D-mW		none
SIG CONV	n/a off on		23	off

Notes:

1.The extended setting range for the IMACS-200 E&M port is from -16.3to +7.5 dB.

2.When a WAN or SRV port has not been selected, or when the mode it to, the default for Signal Conversion is n/a. When the mode has been selected to be e&m, then the default is off.

E&M Ports 7-7