TYPE
The Type informational field shows the current status of the signal field selected on the main E&M port screen for this port. Valid settings for E&M and wink modes is loop (loop start).
STATUS
The Status field shows the current status of the port. Table
| Table |
|
|
Setting | Meaning |
|
|
stdby | The E&M port is in standby. |
W stb | WAN port to which the E&M port is assigned is in standby. |
W tst | WAN port to which the E&M port is assigned is under test. |
W OOS | WAN port to which the E&M port is assigned is out of service. |
noWAN | There is no WAN port configured in the slot to which the E&M port is |
| assigned. |
|
|
call | Call |
busy | Call is in progress. |
idle | No call is in progress (port is available for a call). |
TC | The port is in Trunk Conditioning because a CGA alarm occurred on the |
| associated WAN port. |
|
|
test | A test is in progress on the port (i.e., you are actively controlling the circuit |
| by setting values for Tx ABCD or Rx ABCD). |
|
|
maint | The port is in a maintenance condition. |
E&M Ports |
