Zhone Technologies IMACS-200 HSU Setting Options and Defaults, Parameter User Options Default

Undo	Returns all settings to the last saved state.
Refresh	Updates certain time-related information fields that are not automatically
	updated (i.e., performance and test data).
Copy	Copies the contents of the current column to the next column. Useful if you
	change a lot of entries in one column and want to repeat those changes in
	subsequent columns.
Test	Initiates and monitors testing of all HSU Card ports. Refer to the Test section
	of this chapter.
Main	Returns to the System Main Screen. If changes are made to settings and not
	saved, you will be prompted to save or lose changes.

Table 9-2. HSU Setting Options and Defaults

Parameter	User Options	Notes	Default
STATE	stdby actv		stdby
WAN	wan-1 wan-2 wan-3 wan-4 owan-1 owan-2		wan-1
	owan-3 owan-4
MODE	dce		dce
TS	table	1	table
RATE	64k 56k		56k
TX CLOCK	int ext		int
Tx CLOCK PLRTY	norm inv		norm
Rx CLOCK PLRTY	norm inv		norm
DATA PLRTY	norm inv		norm
CTS	perm rlocal ignor local		perm
CTS DELAY	0 30 60 100		0
LOCAL LB	off dte net		off
LB GEN MODE	v.54 ft1		v.54
LB GEN	off ds0		off
LB DET	w/to on off		w/to
EER THRHD	off 10e-4 10e-5 10e-6 10e-7 10e-8 10e-9		off

Notes:

1. The valid range displayed is from 1-24for T1, and 1-31for E1.

STATE

The State setting determines whether the port is active or inactive. An inactive port does not occupy time slots on a WAN link. Set State to standby (stdby) for ports you are not using or have not yet configured. Set it to active (actv) for ports that are ready for use. The control leads assume the status shown in Table 9-3for the different states.

High Speed Data Ports 9-3