TO NTWK

In cross-connect systems only, the To Network parameter allows you to break the circuit and send a test tone on the network side of the system. The options for this field are none, and D-mW. Choose none if you do not want to inject a tone toward the network. In this case, the PCM signal received from the CPE is still sent to the network in the normal manner.

Tx ABCD

The Transmit ABCD informational field shows the current values of the ABCD bits that are being transmitted to the network. If TX ABCD in the top half of the screen is changed via the set function mentioned above, and the settings are saved by the Save command in the Menu of Actions, the new bit pattern chosen will be reflected here.

Rx ABCD

The Receive ABCD informational field shows the current values of the ABCD signaling bits that are received from the network. If RX ABCD in the top half of the screen is changed via the set function mentioned above, and the settings are saved by the Save command in the Menu of Actions, the new bit pattern chosen will be reflected here.

MODE

The Mode informational field shows the current mode of the port that was selected on the main FXS port Screen. Valid settings are fxs.

TYPE

The Type informational field shows the current status of the signal field selected on the main FXS port screen for this port. Valid settings for fxs and wink modes is loop (loop start).

STATUS

The Status field shows the current status of the port. Table 6-5lists and describes all of the possible conditions reported by this field.

 

Table 6-5. Status Information Field Settings

 

 

Setting

Meaning

 

 

stdby

The FXS port is in standby.

W stb

WAN port to which the FXS port is assigned is in standby.

W tst

WAN port to which the FXS port is assigned is under test.

W OOS

WAN port to which the FXS port is assigned is out of service.

FXS Ports

6-9

Page 157
Image 157
Zhone Technologies IMACS-200 manual To Ntwk, Type, Status Information Field Settings, Setting Meaning