Command Set | 5013 RTD Input | |
|
|
|
$aaSi5mm |
| $aaSi5mm |
Name | Enable/Disable Channels for multiplexing | |
Description | Enables/Disables multiplexing for separate channels of | |
| the specified input module |
|
Syntax | $aaSi5mm(cr) |
|
| $ is a delimiter character. |
|
| aa (range | |
| address of the | |
| Si identifies the I/O slot of the system. | |
| 5 represents the enable/disable channels command. | |
| mm are two hexadecimal values. Each value is interpret- | |
| ed by the module as 4 bits. The first | |
| second | |
| 3. A value of 0 means the channel is disabled, while a | |
| value of 1 means the channel is enabled. (See the Read | |
| Channel Status Command $aaSi6). | |
| Note: Bit 4 can not enable a channel in the ADAM- |
| 5013 since the module is physically limited to 3 |
| channels. |
| (cr) is the terminating character, carriage return (0Dh) |
Response | !aa(cr) if the command is valid. |
| ?aa(cr) if an invalid operation was entered. |
| There is no response if the module detects a syntax error |
| or communication error or if the specified address does |
| not exist. |
| ! delimiter character indicating a valid command was |
| received. |
| ? delimiter character indicating the command was |