Figure 5-6: Save the information of connected modules to txt file.... 5-12
Figure 5-7: Setup options.................................................................. 5-12
Figure 5-8: Checksum function enabled.......................................... 5-15
Figure 5-9: The connection for the Data Scope function ..................5-16
Figure 5-10: Monitor the issuing commands from PC#1................... 5-17
Figure 6-1: Baud rate codes................................................................6 -6
Figure 6-2: Analog module error codes............................................ 6-18
Figure 6-3: Data format for 8-bit parameters.................................... 6-38
Figure 6-4: Data format of 8-bit parameters..................................... 6-92
Figure A-1: Power supply connections............................................... A-4
Figure A-2: ADAM-5000 system hook-up and configuration...............A-6
Figure A-3: Grounding the INIT* terminal..........................................A-10
Figure A-4: ADAM-5000 network system hook-up............................ A-11
Figure C-1: Daisychaining.................................................................. C-3
Figure C-2: Star structure....................................................................C -4
Figure C-3: Random structure............................................................ C-5
Figure C-4: ADAM-4000 and ADAM-5000 in a network...................... C-6
Figure C-5: Signal distortion............................................................... C-7
Figure C-6: Termination resistor locations......................................... C-8
Figure C-7: RS-485 data flow control with RTS.................................. C-9
Figure E-1: Grounding Scheme......................................................... E- 2
Figure E-2: External Terminal Block and Fan..................................... E-3
Figure E-3: Grounding for on-site facilities and ADAM-5000/4000
Systems........................................................................... E -4
Figure E-4: Grounding for signal wires.............................................. E-4
Figure E-5 : Grounding Reference ...................................................... E-5
Figure F-1: Think the EARTH as GROUND......................................... F-3
Figure F-2: Grounding Bar................................................................... F-4
Figure F-3: Normal mode and Common mode..................................F-5
Figure F-4: Normal mode and Common mode..................................F-6
Figure F-5: The purpose of high voltage transmission...................... F-7
Figure F-6: wire impedance................................................................ F-7
Figure F-7: Single point groundinF. (1)............................................... F-8
Figure F-8: Single point groundinF. (2)............................................... F-9
Figure F-9: Single isolated cable........................................................ F-9
Figure F-10: Double isolated cable.....................................................F-10