
www.supportme.net
WARNING: Be sure all wiring complies with the National Electrical Code and all regional and
local codes. Improper wiring may result in unsafe conditions.
WARNING: Be sure that you are completely familiar with the safe operation and programming of this equipment. This equipment may be connected to other machines that have rotating parts or parts that are controlled by this equipment. Improper use can cause serious or fatal injury.
WARNING: The stop input to this equipment should not be used as the single means of achieving a safety critical stop. Drive disable, motor disconnect, motor brake and other means should be used as appropriate.
WARNING: Improper operation or programming of the drive may cause violent motion of the motor and driven equipment. Be certain that unexpected motor movement will not cause injury to personnel or damage to equipment. Peak torque of several times the rated motor torque can occur during control failure.
WARNING: When operating a rotary motor with no load coupled to its shaft, remove the shaft key to prevent it flying out when the shaft rotates.
WARNING: A regeneration resistor may generate enough heat to ignite combustible materials. To avoid fire hazard, keep all combustible materials and flammable vapors away from the brake resistors.
CAUTION: To prevent equipment damage, be certain that the input power has correctly sized protective devices installed.
CAUTION: To prevent equipment damage, be certain that input and output signals are powered and referenced correctly.
CAUTION: To ensure reliable performance of this equipment be certain that all signals to/from the drive are shielded correctly.
CAUTION: Suitable for use on a circuit capable of delivering not more than the RMS
symmetrical short circuit amperes listed here at rated voltage.
Horsepower | RMS Symmetrical Amperes |
5,000 |
CAUTION: Avoid locating the drive immediately above or beside heat generating equipment, or directly below water or steam pipes.
CAUTION: Avoid locating the drive in the vicinity of corrosive substances or vapors, metal particles and dust.
CAUTION: Do not connect AC power to the drive terminals U, V and W. Connecting AC power to these terminals may result in damage to the drive.
MN1942 | General Information |