Cisco Systems SPA9000 manual Configuring Voice Service and Voicemail

C H A P T E R 3

Configuring Voice Service and Voicemail

This chapter describes how to configure voice use voicemail with the SPA9000 and includes the following sections:

•Using the Wizard to Configure ITSP Voice Services and Voicemail, page 3-1

•Completing the Voicemail Configuration, page 3-6

•Configuring the SPA400 for PSTN Connectivity or Voicemail, page 3-8

•SPA400 Voicemail Options, page 3-20

•Configuring a SPA IP Phone for Voice Mail Service, page 3-18

•Managing Voicemail, page 3-20

Using the Wizard to Configure ITSP Voice Services and Voicemail

After using the Setup Wizard to complete the initial configuration of the SPA9000 (see the “Using the Wizard for Initial Configuration” section on page 2-13) the system displays the Main Menu (Figure 3-1). Complete the following steps to set up voice services or voicemail with an ITSP.

Note If you use the Setup Wizard after using the administration web server to change your configuration, you may lose any changes to the factory default configuration that were made using the administration server.

Step 1 If you have closed the Setup Wizard, perform these steps to display the Main Menu.

1.Start the Wizard by double-clicking the executable file.

2.Click Next until you get past the introductory screens.

3.Select I have configured the SPA9000 using the Wizard before and click Next again.

4.On the screen that appears, enter the IP address of the SPA9000 and a password if it is set The system displays the Main Menu.

To configure voice services or voicemail with an ITSP, complete the following steps.

	Linksys SPA9000 Administrator Guide
Document Version 3.01		3-1