
Chapter 2 Getting Started
Initial Setup and Configuration
Licensing
The SPA9000 is shipped from the factory with a
Using DHCP or Static IP Addressing
Before running the Setup Wizard, you need to decide whether you are using DHCP or static IP addressing. Static IP addressing is recommended for the SPA400. The SPA900 series phones typically obtain their addresses through the DHCP server on the broadband router that connects to the broadband modem. The SPA9000 can either be assigned a static address if this has been provided by your ISP, or it can be assigned a dynamic IP address by the DHCP server on your router or by the ISP.
If you are using static IP addressing for the SPA400, you need to know the correct static IP address to assign. To determine the dynamically assigned address of the SPA400, you can use the Setup Wizard or view the DHCP client table for the broadband router.
To determine the current IP address of the SPA9000, complete the following steps.
Step 1 Connect an analog telephone to one of the FXS
Step 2 Press **** on the keypad to access the IVR menu.
Step 3 Press 110# and note the response.
Using the Wizard for Initial Configuration
Step 1 After completing the required physical network connections and powering on all devices, start the SPA Setup Wizard.
The latest wizard can be obtained at the following URL: www.linksys.com/
Figure 2-7 shows the first screen that you should see.
|
| Linksys SPA9000 Administrator Guide |
|
| |
|
|
| |||
| Document Version 3.01 |
|
|
| |
|
|
|
|